1. The slurry pump does not suck water: This phenomenon may be that the steering is wrong or the impeller is damaged and the inhalation tube is blocked. When this phenomenon occurs, you need to check the steering, replace the new impeller, and eliminate the blockage.
2. When the axis power of the slurry pump is too large: friction, bearing damage, the tight driving belt of the bearing, the tightly driving device’s belt, the high speed of the driving device, the high proportion. The pump shaft is not right or unable to parallel; at this time, the solution is to eliminate friction, replace the bearings, adjust the belt, adjust the operating conditions of the pump, adjust the speed, adjust the motor shaft and pump axis.
3. Excessive heat of the slurry pump bearing: there will be too much or too little lubricating grease, the grease mix others and the bearing damage
4. The submersible slurry pump working time shorter than before: the reason for this on -site may be that the motor shaft and pump shaft may be incorrect or not parallel, axis bending, friction in the slurry pump, or the impeller lost balance, the bearings Entering foreign bodies or improper lubrication, and unreasonable bearing equipment; at this time, we need to do the adjustment of the motor shaft and pump shaft, change the axis, eliminate friction, change new impeller, clean the bearings, change the bearings or reassemble the shaft.
5. When detecting the vibration of the slurry pump and the noise high, the bearing damage, the imbalance of the leaf wheel, the unevenness of the flow, and the unevenness of the flow may occur. What we need to do is to change the new bearing, the new impeller, and the pump inlet.
If you have any questions about yoru submersible slurry pump or need change some parts, new slurry pumps, please contact us freely.
Email: rita@ruitepump.com
Web: www.ruitepumps.com
Post time: Oct-24-2023